Most hot mix asphalt driveways in Palmer Lake should finish at 2 to 3 inches of compacted asphalt over 6 to 8 inches of compacted aggregate base. Where an RV, trailer or delivery truck uses the drive, plan on 3 to 4 inches. The right number for your lot depends on what parks on it, the soil underneath, the slope, and whether the asphalt sits on a gravel base or is built full depth.
Palmer Lake sits high on the Palmer Divide in El Paso County, and the snow and cold up here can push a driveway toward the upper end of each range. Paul's Asphalt handles grading, gravel base installation and hot mix asphalt for Palmer Lake driveways.
How Thick Hot Mix Asphalt Should Be for a Residential Driveway in Palmer Lake
Hot mix asphalt for a residential driveway in Palmer Lake should be 2 to 3 inches thick after compaction for everyday cars and 3 to 4 inches for heavier vehicles, with 6 to 8 inches of compacted base underneath. A drive that only sees one or two cars can work at 2 inches over a 4 to 6 inch base.
From the bottom up, a typical residential section looks like this: 6 to 8 inches of compacted crushed aggregate base, about 2 inches of dense-graded hot mix base course, then about 1.5 inches of hot mix surface course.
Two driveways of the same size can still need different sections. A two-car household in Woodmoor and a home in Ben Lomand that parks a camper beside the garage are not asking the same thing of their asphalt.
Why Published Thickness Numbers Disagree
Published thickness numbers disagree because they describe two different builds. Most guides assume asphalt over an aggregate base. Full depth means the entire section is asphalt on prepared soil. In that case 4 inches may be adequate, while 5 or 6 inches gives a stronger drive across more climates and loads.
The Illinois Asphalt Pavement Association cites a National Asphalt Pavement Association rule: 1 inch of asphalt does the work of 3 inches of aggregate base. By that ratio, 3 inches of hot mix over 6 inches of base behaves close to a 5 inch full-depth section. Both figures can be right. Check which build your quote describes.
Why Palmer Lake Driveways Can Lean Toward the Upper End of the Range
Palmer Lake driveways can lean toward the thicker end because the town sits high and cold. It lies at 7,139 feet on the Palmer Divide, the ridge that separates the Arkansas and Platte drainages.
Nearby Monument averages about 111 inches of snow a year, against about 33 inches in Colorado Springs, and has recorded a low of minus 27 F. Snow means plowing, piled banks and meltwater running across the surface for months.
Industry guidance ties extra asphalt depth to a stronger driveway in tougher climates and under heavier loads. For a home on the Divide, that points to the upper part of the 2 to 3 inch range, and to the deeper part of the 6 to 8 inch base range where the soil is weak.
Sloped Lots Near Pike National Forest and Long Drives in Black Forest
Sloped lots and long rural drives need the most care with thickness and base. Pike National Forest borders Palmer Lake on the west, and a home on sloped ground there needs a drive that sheds water without washing out its edges.
Black Forest, at 7,369 feet, was zoned mostly for five-acre minimum lots in 1965. That often means long drives with more surface to build. Paul and his crew take on varying slopes and long rural driveways. As one customer put it, "I had a difficult driveway to pave due to varying slope and Paul and his crew did a great job."
The Base Under a Palmer Lake Hot Mix Driveway
The base under a Palmer Lake hot mix driveway should be 6 to 8 inches of compacted aggregate when the drive gets 3 inches of asphalt. The soil below matters just as much. The subgrade needs thorough compaction, clay topsoil should be removed or modified, and if the ground is not firm and dry, paving should wait.
The surface also needs a slope of at least 2 percent so water drains off. Whether the lot is on the north side near Greenland Open Space Preserve or off Lower Glenway, the work follows the same order:
- Grade the site and compact the subgrade until it is firm and dry.
- Remove or treat clay topsoil.
- Place and compact the aggregate base to full depth, 6 to 8 inches for a standard drive.
- Shape the base so the finished surface drains at 2 percent or more.
- Place the hot mix in lifts and compact each lift before the next.
Compacted Thickness Versus the Depth Laid Down
Compacted thickness is the number that counts, and it is always less than the depth laid down. Specified asphalt thicknesses are compacted depths. Compacted hot mix is typically about three quarters of its loose depth, so a 4 inch loose lift rolls out to about 3 inches. If a quote says "3 inches," it should say whether that means loose or compacted. Ask for the compacted thickness of each lift and the compacted base depth in writing.
Thicker drives go down in lifts. A total of 2 to 3 inches can be placed as two layers of 1.5 inches each when compacted. A 4 inch mat is built by placing 2.5 inches, compacting it, then placing and compacting the rest.
| Driveway use | Compacted hot mix | Compacted base | Notes |
|---|---|---|---|
| One or two cars, light use | 2 inches | 4 to 6 inches | Light use only |
| Standard family driveway | 2 to 3 inches | 6 to 8 inches | Upper end suits cold, snowy sites |
| RV, trailer or delivery truck | 3 to 4 inches | 6 to 8 inches | Place in lifts |
| Overlay, old surface in good shape | 1.5 inches | Existing pavement | Patch holes and cracks first |
| Overlay, moderate cracking | 2 inches | Existing pavement | Repair cracks before paving |
| Overlay, significant damage | 2.5 to 3 inches | Existing pavement | Replacement may be the better choice |
- If you park only cars and the lot drains well, then plan on 2 to 3 inches over a 6 to 8 inch base and have Paul's Asphalt check your site at a free consultation.
- If you keep an RV or trailer or take regular deliveries, then plan on a 3 to 4 inch section placed in lifts.
- If your old drive is cracked across large areas, then have Paul and his crew look at it before you choose between an overlay and replacement.
When Hot Mix Can Be Placed on a Palmer Lake Driveway
Hot mix can be placed on a Palmer Lake driveway only when the air and ground are warm enough for the lift being laid. A 1.5 inch lift needs air and surface temperatures above 70 F. A 2 inch lift has a 40 F threshold. The industry chart behind those figures assumes a 300 F delivery temperature, crews need at least 20 minutes to place and compact a lift, and wind shortens that window.
So thickness and timing are linked. Thin lifts need warmer conditions, which makes a thin surface course harder to place well late in the season. Paving season in Palmer Lake winds down in fall, and booking earlier gives you more choice of days.
Before work begins, check whether your project needs a permit. That depends on the property and the work. Town Hall is at 42 Valley Crescent and can be reached at 719-481-2953, and the Town of Palmer Lake website links to the municipal code.
Once the mat is down, the drive needs time before regular use. Our guide on how soon you can drive on freshly paved asphalt in Palmer Lake covers that part.
Why Palmer Lake Homeowners Hire Paul's Asphalt for Hot Mix Driveways
Palmer Lake homeowners hire Paul's Asphalt because we are locally owned and handle the whole driveway section, from grading to hot mix paving. We have served Palmer Lake and the surrounding communities for 10 years from 702 Highway 105, hold an A+ BBB rating and carry 4.8 stars on Google.
- Grading, base and paving. We do grading, gravel base installation and hot mix paving, so base depth and asphalt thickness are planned as one job.
- The owner on site. Paul works on jobs himself. One customer wrote, "Paul responded to my request the very next day and then the following day they paved our driveways."
- Tough sites. Paul and his crew handle varying slopes and long rural driveways, and reviews mention jobs in Chaparral Hills.
- Follow-through. Paul and his crew come back to fix issues after the job.
- A free consultation. We offer free consultations to go over your lot and your driveway plans.
We also pave driveways in Monument, Larkspur, Gleneagle and across El Paso County, and our phone line is open 24 hours.
The Bottom Line
A residential hot mix driveway in Palmer Lake should usually finish at 2 to 3 inches of compacted asphalt over 6 to 8 inches of compacted base, with 3 to 4 inches for RVs, trailers and delivery trucks. Snow on the Palmer Divide, weak soils and sloped or long drives all argue for the upper end. Make sure your quote states the compacted thickness, the number of lifts and the base depth. For grading, gravel base installation and hot mix asphalt paving in Palmer Lake, call Paul and his crew at (719) 232-1523 to set up a free consultation.
Providing Asphalt Contractor Services to Palmer Lake and the Greater Colorado Springs Area
Request a Quote
