Free on-site estimates(719) 232-1523
Paul's AsphaltService LLC · Colorado
Call (719) 232-1523 Request a Free Estimate

Paving Guide

What Is The Typical Installed Cost Of A 20-by-20-Foot (400 Sq Ft) Asphalt Driveway?

A 20-by-20 asphalt driveway costs $1,600–$3,200 installed in 2026. Learn what's included, what raises the price, and how long it lasts in Palmer Lake, CO.

The typical installed cost of a 20-by-20-foot (400 sq ft) asphalt driveway ranges from $1,600 to $3,200 in 2026, or $4 to $8 per square foot. That price covers site grading, a compacted gravel base, hot-mix asphalt, and roller compaction. It doesn't include seal coating, decorative edging, or removal of an existing driveway surface. In mountain communities like Palmer Lake, CO, elevation, soil conditions, and distance from the nearest asphalt plant tend to push costs toward the higher end of the range. The final number also shifts based on whether the old surface needs to be demolished, how steep the slope is, and how thick the asphalt layer is specified to be. Getting two or three itemized bids from local contractors gives you the clearest picture of what your specific site will cost.


What does a 400 sq ft asphalt driveway cost per square foot?

A 400 sq ft asphalt driveway costs $4 to $8 per square foot installed in 2026, putting the total between $1,600 and $3,200. The low end applies to flat lots with easy truck access and no demolition of an old surface. The high end is where you land with sloped yards, poor soil, or sites located far from an asphalt plant.

Palmer Lake, CO sits at roughly 7,000 feet elevation. Mountain haul routes from the Colorado Springs area add cost compared to lower-elevation metro projects — that's just the reality of working up here. Contractors typically quote a flat project price, but knowing the per-square-foot rate helps you compare bids side by side.

Price range breakdown for a 400 sq ft asphalt driveway (2026):

  1. Low end ($1,600 total / $4 per sq ft): Flat lot, easy access, no demo, close to asphalt plant.
  2. Mid-range ($2,000 total / $5 per sq ft): Minor grading needed, standard soil, average haul distance.
  3. High end ($2,800 total / $7 per sq ft): Sloped yard, soft or clay soil, limited truck access.
  4. Palmer Lake typical ($2,400 to $3,200 / $6 to $8 per sq ft): Elevation surcharge, mountain haul route, freeze-thaw base requirements.
  5. With old surface demolition added: Ask your contractor to separate the demo cost as its own line item so you can see exactly what breaking up and hauling away the existing driveway adds to the total.

How much does asphalt material cost for a small driveway?

For a project this size, raw hot-mix asphalt material is only a portion of the overall installed price. The larger share covers labor, equipment, base material, grading, and fuel. Material cost alone doesn't reflect what you'll pay for a finished, installed driveway. Your contractor's quote will bundle these components together, which is why comparing itemized bids is the most reliable way to understand where your money goes.


What is included in the installed price of an asphalt driveway?

A standard installed asphalt driveway price covers site grading, a compacted gravel base, hot-mix asphalt, and roller compaction. Each step is part of the base bid from most asphalt contractors.

Grading levels the ground so water drains away from the home. That step matters a lot in Colorado's freeze-thaw climate, where poor drainage lets ice build up under the surface and crack it from below. We've seen what skipped or rushed grading does to a driveway after two or three winters, and it's never a small repair bill.

A compacted crushed-stone base (typically 4 to 6 inches deep) supports the asphalt layer above and prevents rutting and cracking. Hot-mix asphalt is then laid at 2 to 3 inches for a standard residential driveway. A roller or plate compactor presses the asphalt smooth and locks in the surface texture.

Included in Standard Install Not Included (Separate Line Items)
Site grading and leveling Old driveway demolition and haul-away
Compacted gravel base (4 to 6 inches) First-time seal coating
Hot-mix asphalt (2 to 3 inches) Decorative edging or borders
Roller compaction Drainage pipe or culvert installation
Basic surface smoothing Permitting fees (if required locally)

Does the quote include removing my old driveway?

Demolition of an existing driveway is almost always a separate line item, not part of the base paving price. Old asphalt or concrete has to be broken up, loaded, and hauled away before new grading can begin.

Demolition costs vary based on surface material, thickness, and haul distance. Ask your contractor to separate the demo cost in the written bid so you can see exactly what each phase costs. If that line item is buried or missing, ask again.


What factors raise or lower the cost of a 20-by-20 asphalt driveway?

Five main factors move the price of a 20-by-20 asphalt driveway up or down: site slope, soil quality, access for trucks, distance from the asphalt plant, and time of year.

  1. Site slope: Steep slopes require more grading labor and may need retaining borders at the edges. On a small project like this, that extra work adds to the total cost.
  2. Soil quality: Soft or expansive soil needs extra base material to create a stable foundation. Colorado's clay-heavy soils found in some Palmer Lake neighborhoods are a known cost driver because they shift with moisture changes.
  3. Truck access: Narrow driveways, low-hanging trees, or gated entries limit equipment size and slow the job down. Expect a surcharge if a full paving truck can't reach the site and smaller equipment has to be used.
  4. Haul distance from the plant: Asphalt plants charge a haul fee per mile. Rural Palmer Lake properties located farther from Colorado Springs area plants pay more per ton because the mix has to arrive hot and on time.
  5. Time of year: Spring and early summer are peak demand for paving contractors in Colorado. Scheduling during off-peak periods may lower quotes, though weather windows close earlier at elevation.

Does Colorado's altitude affect asphalt driveway costs?

Altitude does affect asphalt paving at Palmer Lake's elevation. Hot-mix asphalt cools faster at 7,000 feet than at lower elevations because temperatures drop more sharply in the evening up here. Faster cooling gives the crew less working time, which can slow production and increase labor cost on a per-job basis.

Some mix designs are adjusted for high-altitude applications to stay workable longer. A contractor familiar with mountain paving will spec the right mix and plan the pour time to match those conditions. We've had to adjust our timing and mix selection on jobs up here, and it's not something a contractor who only works in the Springs thinks about.


How thick should a 20-by-20 asphalt driveway be?

A residential asphalt driveway for standard passenger vehicles should be at least 2 to 3 inches of compacted hot-mix asphalt over a 4 to 6 inch compacted gravel base. Those are the minimum specs for a driveway expected to last 20 or more years.

Thinner installs under 2 inches crack faster, especially in freeze-thaw climates like Palmer Lake where the ground freezes hard each winter. A 3-inch asphalt layer uses more material than a 2-inch layer, and the added thickness reduces cracking and extends the surface life. Worth it, in our experience.

Base depth matters just as much as asphalt depth. A weak or shallow base causes rutting and surface deformation even when the asphalt layer itself meets spec. Money saved on base prep almost always shows up as early repairs, and we've seen that play out on driveways that were barely three years old.

If you regularly park a truck, RV, or trailer on the driveway, ask your contractor about a 4-inch asphalt layer. The added thickness handles heavier point loads without rutting.

What base depth does Colorado's freeze-thaw cycle require?

Frost depth in the El Paso County and Tri-Lakes region reaches approximately 36 inches. That means the ground beneath your driveway freezes and thaws repeatedly each year, creating movement that pushes up weak bases and cracks thin asphalt above them.

A compacted gravel base of 6 inches is the practical minimum for Palmer Lake driveways. Some contractors recommend deeper base work on sites with clay soil or poor drainage. The asphalt pavement design guidelines published by the U.S. Department of Transportation Federal Highway Administration provide the structural depth standards that professional contractors reference when speccing base requirements for cold-climate installations.


How does a 20-by-20 asphalt driveway compare to concrete in cost?

A 400 sq ft concrete driveway typically costs more per square foot than asphalt, making asphalt the lower upfront cost option for most homeowners. Concrete installation generally runs higher than asphalt for a project this size; get local bids on both materials to compare current pricing in the Palmer Lake area.

Asphalt has a lower first cost but benefits from periodic seal coating to stay in good condition. Concrete needs little routine maintenance but costs more to repair when cracks develop, because concrete patches are harder to blend invisibly than asphalt repairs.

In Palmer Lake's climate, asphalt handles freeze-thaw cycles well. It's flexible enough to move slightly with ground heave and settle back without fracturing. Concrete is rigid, and repeated freeze-thaw cycles can open and widen cracks over time. That rigidity works against you up here.

Category Asphalt (400 Sq Ft) Concrete (400 Sq Ft)
Upfront installed cost $1,600 to $3,200 Higher — get local bids to compare
Lifespan 20+ years with proper maintenance Longer potential lifespan under ideal conditions
Routine maintenance Periodic seal coating recommended Minimal
Repair ease Easy, blends well Visible patches, higher cost
Freeze-thaw performance Moves with the ground, less likely to fracture Rigid, more likely to crack with repeated heave

Concrete can last longer when conditions are ideal. Asphalt costs less upfront and performs more reliably in mountain climates with hard winters and significant ground movement. For most Palmer Lake homeowners, that's the right trade-off.


How long does a 400 sq ft asphalt driveway last?

A properly installed 400 sq ft asphalt driveway can last 20 or more years in Colorado when the base is solid and the surface is sealed on a regular schedule. Palmer Lake's elevation means hard winters and significant freeze-thaw cycling, which shorten lifespan when the driveway is thin or the base is weak.

Sealing the surface fills pores, slows UV oxidation, and keeps water from working its way into the asphalt layer. Skip that step and you'll see the surface go gray and start cracking on its own schedule, and at 7,000 feet that happens faster than most people expect. We tell every customer the same thing: sealing is the cheapest maintenance you can do.

Small cracks filled early in the driveway's life prevent water from reaching the base. Water trapped in the base freezes, expands, and pushes the surface up from below. That's the most common cause of early asphalt failure in cold climates, and it's almost entirely preventable. Call us for a crack fill before the base gets involved.

When should you replace instead of repair a small asphalt driveway?

As a general guideline used in the paving industry, when repair costs begin to approach the cost of full replacement, replacement is worth pricing out for comparison. On a 400 sq ft driveway, getting a replacement quote alongside any major repair estimate helps you understand which option offers better long-term value. Sometimes a repair is the right call. Sometimes you're putting money into something that's done, and it's better to know that up front.

Widespread alligator cracking (a pattern of interconnected surface fractures that looks like lizard skin) signals base failure. Patching the surface without fixing the base only delays the same problem by a few years. No exceptions.


What extra costs should you budget for after installation?

After a new 400 sq ft asphalt driveway is installed, budget for first-time seal coating, annual crack inspection, and periodic resealing over the driveway's life. These post-installation costs are easy to overlook when comparing upfront bids, but including them gives a more honest total-cost picture.

  1. First seal coat: Plan to wait several months after installation before applying the first sealer, giving the asphalt time to cure fully. Get a local quote for 400 sq ft when the time comes, as rates vary by contractor and season in the Palmer Lake area.
  2. Annual crack inspection: Small cracks appear as asphalt cures and seasons through its first winter. Filling cracks early is an inexpensive step that prevents water from reaching the base layer below.
  3. Periodic resealing: Resealing on a schedule recommended by your contractor adds a lifetime maintenance cost spread across the driveway's useful life. The exact amount depends on labor rates at the time each coat is applied.
  4. Edge maintenance: Driveways without concrete or steel borders chip at the edges over time. Adding edging strips or a concrete border at installation reduces long-term edge repair bills. A 20-by-20-foot driveway has 80 linear feet of perimeter, so ask your contractor for an edging add-on quote when you receive your initial bid.

For a site-specific quote in the Palmer Lake and Tri-Lakes area, see our asphalt driveway paving services in Palmer Lake, CO.


The bottom line

A 20-by-20-foot asphalt driveway costs $1,600 to $3,200 installed in 2026, with Palmer Lake's elevation and site conditions often pushing quotes to the mid-to-high end of that range. Price is shaped by base depth, asphalt thickness, site access, and haul distance, so getting two or three itemized quotes helps you understand what each contractor is actually bidding. Factor in seal coating and crack maintenance over the driveway's life and you'll have a realistic number, not just the install price. Colorado's freeze-thaw cycles are hard on asphalt that isn't maintained, and a little attention early goes a long way.

Want an exact number for your driveway? Call Paul's Asphalt Service, the asphalt contractor in Palmer Lake that gives free on-site estimates, at (719) 232-1523.

Ready for pavement that lasts?

Call Paul's crew for a free, no-pressure estimate. You'll get a straight answer on what your pavement needs and what it will cost.

Illustration of a Paul's Asphalt dump truck on a mountain road
Call Now Free Estimate